Load tests
Load tests successfully carried out - excellent results
The test setup at our manufacturing facility in Lemwerder, D.
These measurements prove that the design and manufacture of the rotor arms were done flawlessly and with the highest quality. Compliments to all involved!
Last week, the planned load tests could be carried out at our manufacturing facility in Germany. The aim of the tests was to check the quality of the composite work as well as the calculations of the rotor arms. In the test setup, loads were first applied to the intended forces. No damage was observed. After that, loads were applied until failure. The measured force corresponded to more than twice the design load.
Imprint | Disclaimer | Login